User guide

Figure 3-2

3.1.3 Remove Lens

Please follow the steps listed below to remove lens. The interface is shown as in Figure 3-3.

z Turn the lens counter clockwise and then remove it from the camera.

z Unplug the auto lens cable socket from the auto lens connector. If you are using the manual

aperture lens, please skip to the following step.

z If there is no lens, please put the CCD protection cap back to protect the CCD.

Figure 3-3

3.2 I/O Port

Install Cable

Please follow the steps listed below to install the cable. See Figure 3-4.

Use the small slotted screwdriver to press the corresponding button of cable groove. Insert the

cable into the groove and then release the screwdriver.

Remove Cable

Please follow the steps listed below to remove the cable.

Use the small slotted screwdriver to press the corresponding button of cable groove. Remove the

cable out of the groove and then release the screwdriver.