User Manual

31
The TCP/IP interface is shown as in Figure 5-11.
Figure 5-11
Please refer to the following sheet for detailed information.
Parameter
Function
Host Name
It is to set current host device name. It max supports 32-digit
character.
Ethernet Card
Please select the Ethernet port. It is for the wire LAN by default.
Please note for the -W series product, it has the wireless
network card, and you can modify the default Ethernet port
setup.
Please note the device needs to reboot to activate the new
setup once you modify the default setup.
Mode
There are two modes: static mode and the DHCP mode.
 The IP/submask/gateway are null when you select the
DHCP mode to auto search the IP.
 If you select the static mode, you need to set the
IP/submask/gateway manually.
 If you select the DHCP mode, you can view the
IP/submask/gateway from the DHCP.
 If you switch from the DHCP mode to the static mode, you
need to reset the IP parameters.
 Besides, IP/submask/gateway and DHCP are read-only
when the PPPoE dial is OK.
Mac Address
It is to display hose Mac address.