User Manual

34
HTTPs
Enable
The default value is 443.
5.2.3 PPPoE
The PPPoE interface is shown as in Figure 5-13.
Input the PPPoE user name and password you get from the IPS (internet service provider) and enable
PPPoE function. Please save current setup and then reboot the device to get the setup activated.
Device connects to the internet via PPPoE after reboot. You can get the IP address in the WAN from
the IP address column. When PPPoE is on, please disable UPnP to avoid influence on dial-up.
Please note, you need to go to the IP address item to via the device current device information.
You can access the client-end via this address.
Figure 5-13
5.2.4 DDNS
The DDNS interface is shown as in Figure 5-14.
The DDNS is to set to connect the various servers so that you can access the system via the server.
Please go to the corresponding service website to apply a domain name and then access the system
via the domain. It works even your IP address has changed. When the device connects to WLAN, you
should disable UPnP.