User Manual

56
5.3.2 Alarm
Please note some series products do not support this function.
5.3.2.1 Alarm activation
The alarm activation interface is shown as in Figure 5-35.
Figure 5-35
Please refer to the following sheet for detailed information.
Parameter
Function
Enable
After enabled, relay activation will work.
Alarm input
The default is alarm 1 and for some devices may be alarm 2.
Working
period
 This function becomes activated in the specified periods.
 There are six periods in one day. Please draw a circle to
enable corresponding period.
 Select date. If you do not select, current setup applies to
today only. You can select all week column to apply to the
whole week.
 Click OK button, system goes back to motion detection
interface; please click save button to exit.
Anti-dither
System only memorizes one event during the anti-dither period.
The value ranges from 0s to 100s.
Sensor type
There are two options: NO/NC.
Flash
After enabled, when alarm occurs, the system will turn on flash.
Note: Only some series support flash.