User Manual

This series network camera product supports the Web access and

management via PC.

4A. NETWORK CONNECTION

Please follow the steps listed below for network connection.

● Make sure the network camera is connected to the network and

powered properly.

● Please set the IP address, subnet mask and gateway of the PC

and the network camera respectively. The camera is set to DHCP

out of the box with default IP address of 192.168.1.108 if DHCP

pool is not available. Subnet mask is 255.255.255.0. Gateway is

192.168.1.1

● Using Command Prompt, type “ping ***.***.***.***(* network

camera address)” to check if connection is OK or not.

4B. LOGIN AND LOGOUT

Open IE or Chrome and input the network camera address in the

address bar. See Figure 4-1.

MARGIN

GUIDES

Stay within the yellow

box. Do not let text go

beyond, instead move

to the next column or

start a new page.

7 | www.icrealtime.com

Figure 4-1

The login interface is shown as below. See Figure 4-2.

Note: If it is your ﬁrst time logging into the camera (and it has not

been initialized through the ConﬁgTool or NVR), the camera will need

to be initialized. A pop-up will appear to select your region. After

selecting region, you will be prompted to create a password for the

admin account as well as security questions in case the password is

lost After initializing, you will be able to login to the web interface of

the camera.

Please input your user name and password.

Figure 4-2