User Manual

2A. INSTALLATION STEPS

Important: Before the installation, please make sure the installation

environments can at least support 3x weight of the camera.

Please follow the steps listed below to install the device. Please refer

to Figure 2-1 for reference.

MARGIN

GUIDES

Stay within the yellow

box. Do not let text go

beyond, instead move

to the next column or

start a new page.

3 | www.icrealtime.com

Figure 2-1

Step 1 Use the wrench in the accessories bag to unscrew the three

torx head screws on the dome enclosure and then open the dome

enclosure.

Step 2 Please take out the installation position map from the

accessories bag, and then paste it on the ceiling or the wall according

to your monitoring area requirements.

Step 3 Find “cross”signs on the map, and dig three plastic expansion

bolts holes on the installation surface and then insert three expansion

bolts into the holes. Secure these three bolts ﬁrmly.

Step 4 Adjust the device installation pedestal to the proper position and

then pull cable through the exit hole on the installation surface. Align the

three screw holes in the device pedestal with the three plastic expansion

bolt holes in the installation position. Put the three installation screws

into the three plastic expansion bolts and secure them ﬁrmly. Fix the

pedestal on the installation surface.

Step 5 Adjust the lens to the needed angle according to the application

requirements of the location. Hold the screw location of the rotation

bracket on both sides, turn the rotation bracket horizontally, adjust the

lens direction horizontally to the target position; unscrew the two

locking screws on both sides (do not remove them completely, just make

them loose), hold the IR light decoration cover to make the lens rotate

vertically, adjust the vertical direction of lens to a proper monitoring

angle, then tighten the locking screws on both sides; Hold the IR light

decoration cover to rotate horizontally, adjust the image and adjust the

lens horizontal direction to the targeted location. See Figure 2-2.

Figure 2-2