User Manual

2B. RESTORE FACTORY DEFAULTS

Important: Make sure the device is powered when attempting to press

RESET button.

Step 1 Please refer to Step 1 in Section 2A to remove the dome body.

Step 2 Take the dome body out to expose the inside of the camera.

Step 3 Slightly press the RESET button to complete the reset function.

See Figure 2-4. The camera will reboot when the reset process is

complete.

MARGIN

GUIDES

Stay within the yellow

box. Do not let text go

beyond, instead move

to the next column or

start a new page.

5 | www.icrealtime.com

Figure 2-4

Step 4 Install the top cover back to the original position. Please make

sure the internal seals are installed in the original position, otherwise

it may result in water leakage.

Step 5 Tighten down locking screws. Please refer to Step 5-6 in

Section 2A to install the dome cover.

Figure 3-1

3A. OVERVIEW

The IP Conﬁg tool is used to search the local network for IC Realtime

devices as well as modify the IP addresses and upgrading ﬁrmware.

This software can be downloaded at:

https://icrealtime.com/downloads under Desktop Utility Apps

3B. OPERATION

Double click the “ConﬁgTools.exe” icon to run. The interface will be

displayed as shown in Figure 3-1. Click on the blue circle icon with

the two arrows to refresh and scan the network.