Instruction Manual

Wall Mount Cabinet, 12 & 26 RMS

I N S T A L L A T I O N I N S T R U C T I O N S

888-ASK-4ICC csr@icc.com icc.com

Detail B

DOOR HINGES

ADJUSTABLE DEPTH

FRONT DOOR HINGE

CAUTION!

 Do not overload the cabinet. Cabinet can support up to 150 lbs. of equipment when properly installed using all mounting holes.

 Make sure wall has a structural load capacity that will support the weight of the cabinet fully loaded equipment.

 Do not attempt to lift the cabinet alone.

 Before installation, locate where the cabinet is to be installed; concrete walls, plywood and wooden studs are recommended.

Step 1: Use a level to mark locations for mounting screws as

shown above. Templates and screws are not provided.

ICCMSWMC12: requires four (4) ¼-10 X 2 Lag Screws

ICCMSWMC26: requires eight (8) ¼-10 X 2 Lag screws

Step 2: Drill screws into marked locations without fully tightening

them. Leave at least a .2” gap between screws and wall.

Note: Make sure the screws you are using fit the screws slot shown

in Detail A.

Step 3: Place the Wall Mount Cabinet onto the pre-drilled screws,

then tighten all screws. Screws and screw slots should look like

Detail B when fully tighten.

NOTE: To adjust the depth of the rail, lightly untighten the screw,

adjust to the desired depth and then tighten the screw.

PAGE 1
Wall Mount Cabinet, 12 & 26 RMS I N S T A L L A T I O N I N S T R U C T I O N S CAUTION!     Do not overload the cabinet. Cabinet can support up to 150 lbs. of equipment when properly installed using all mounting holes. Make sure wall has a structural load capacity that will support the weight of the cabinet fully loaded equipment. Do not attempt to lift the cabinet alone. Before installation, locate where the cabinet is to be installed; concrete walls, plywood and wooden studs are recommended.
PAGE 2
Wall Mount Cabinet, 12 & 26 RMS I N S T A L L A T I O N PART NUMBER DESCRIPTION ICCMSWMC12 ICCMSWMC26 22” W x 24” H x 26” D, 12 RMS 22” W x 48” H x 26” D, 26 RMS F E A T U R E S     I N S T R U C T I O N S A N D     Vented panels help circulate air Wall mountable for left or right orientation Cable knockouts on top and bottom: (4) 3.0” and (4) 0.88” Mounting rails for equipment are adjustable O P T I O N A L Single Horizontal Finger Ducts ICCMSCMA41 1.75”H x 3.19”D, 1 RMS ICCMSCMA42 3.