Manual

888-ASK-4ICC csr@icc.com icc.com

INSTALLATION INSTRUCTIONS

Category 5e/6 Mobile Patch Box

Step 1: Disassemble lower body from upper body.

Step 4: Use the supplied cable ties to secure the cable

bundle.

Step 2: Determine between TIA-568-A and TIA-568-B

wiring. IMPORTANT: For maximum performance, minimize

the untwisting of individual pairs to 0.50” maximum.

Step 5: Place lower body on top of upper body. Make

sure strain relief is properly seated. Use screws to secure.

Step 3: Place upper body face down on a ﬂ at and ﬁ rm

surface. Pass cable through the strain relief boot. Lay

the wires on the 110-type IDC and terminate them using

a single blade punch down tool.

Step 6: To access ports, ﬂ ip dust covers open. Dust cover

can be completely removed and a label may be

placed in area provided.

Optional: Use #6 screws (not sold by ICC) to mount box to a wall or ﬂ at surface.

Optional: To mount the mobile patch box on a metal surface, install magnets (not

included) into open slots inside the lower body.

Magnets

Single Blade Punch Down Tool

Strain Relief Boot

IMPORTANT!

PAGE 1
Category 5e/6 Mobile Patch Box I N S T A L L A T I O N I N S T R U C T I O N S Single Blade Punch Down Tool Strain Relief Boot IMPORTANT! Step 1: Disassemble lower body from upper body. Step 2: Determine between TIA-568-A and TIA-568-B wiring. IMPORTANT: For maximum performance, minimize the untwisting of individual pairs to 0.50” maximum. Step 3: Place upper body face down on a flat and firm surface. Pass cable through the strain relief boot.
PAGE 2
Category 5e/6 Mobile Patch Box I N S T L L A T I O N I N S T R U C T I O N S Item # Description Screws Cable Ties ICMPPMB506 CAT 5e, 6-Port, RJ-45, Loaded 4 2 ICMPPMB606 CAT 6, 6-Port, RJ-45, Loaded 4 2 F • A E A T U R E S A N D B E N E F I T S Solution for areas where fixed outlet connectivity is unavailable; such as offices, warehouses, trade shows, conferences and computer labs • Provides up to six data ports • Mounts on flat surfaces using screws