User's Manual

User Manual
18 / 26
Chapter 7 CLI Commands
The command-line interface (CLI) is a software interface providing another way to set the
parameters of equipment from the SSH or through a telnet network connection. To configure it with
CLI commands. After establishing a Telnet or SSH connection with the communication board, enter
the login account and password (default admin/admin) to enter the configuration mode of the
communication board, as shown below.
CLI command：
# ?
! Comments
add Add a list entry of configuration
clear Clear statistics
config Configuration operation
debug Output debug information to the console
del Delete a list entry of configuration
exit Exit from the CLI
help Display an overview of the CLI syntax
ping Send messages to network hosts
reboot Halt and perform a cold restart
route Static route modify dynamically，this setting will not be saved
set Set system configuration
show Show system configuration
status Show running system information
tftpupdate Update firmware using tftp