User's Manual

User Manual
19 / 26
traceroute Print the route packets trace to network host
urlupdate Update firmware using http or ftp
ver Show version of firmware
Following is a table about the description of help and the error should be encountered in the
configuring program.
Commands /tips
Description
?
Typing a question mark “?” will show you the help
information.
eg.
# config（Press ‘?’）
config Configuration operation
# config（Press spacebar +’?’）
commit Save the configuration changes and take
effect changed configuration
save_and_apply Save the configuration changes and
take effect changed configuration
loaddefault Restore Factory Configuration
Ctrl+c
Press these two keys at the same time, except its “copy”
function but also can be used for “break” out of the setting
program.
Syntax error: The command is
not completed
The current command is not completed.
Tick space key+ Tab key
It can help you finish you command.
Example:
# config (tick Enter key)
Syntax error: The command is not completed
# config (tick space key+ Tab key)
commit save_and_apply loaddefault
#config commit
# config save_and_apply
When your setting finished, you should enter those
commands to make your setting take effect on the device.
Note: Commit and save_and_apply plays the same role.
Commands
Syntax
Description
Debug
Debug parameters
Turn on or turn off debug function
Show
Show parameters
Show current configuration of each function , if we
need to see all please using “show running ”
Set
Set parameters
All the function parameters are set by commands set
and add, the difference is that set is for the single
parameter and add is for the list parameter
Add
Add parameters