Technical Manual

GEM-MFI SERIES Operation: Water
Page 25
Water
Water enters the machine through the 3/8 FPT at the rear of the cabinet, goes to the water reservoir which it
enters through the float valve. The water then goes out the bottom of the reservoir tank to the bottom of the
evaporator. Reservoir overflow or evaporator condensation is routed to the drain.
Water Level
The correct water level should be checked when the machine is making ice. Locate the water level in the
reservoir, and compare it to the horizontal line molded into the side of the reservoir. The correct level should
be between 1/8 inch above and 1/4 inch below the line. If needed, bend the float arm up or down to adjust the
water level.
Reservoir
Water Level
Evaporator Drain
Drain
Ice Chute
Water Inlet
Water System
Evaporator Water Inlet