Installation Manual
Table Of Contents
- Table of Contents
- Product Description: Page 2
- Cabinet Dimensions Page 3
- Location Recommendations: Page 4
- Familiarization Page 5
- Door Swing Page 6
- Plumbing - Pump Model Page 7
- Plumbing: Gravity Drain Model Page 8
- Electrical and Start Up Page 9
- Use Page 10
- Maintenance Page 11
- How to remove scale from the ice making system. Page 12
- Service Table of Contents
- Table of Contents
l
Door Swing
The door can be attached to open with hinges on
the left or right. Retain all screws for re-use.
To change:
1. Remove top hinge pin from hinge.
2. Tilt top of door away from cabinet and lift door
off bottom hinge.
3. Remove two screws and top hinge.
4. Remove plugs or screws from lower cabinet
bracket
5. Attach top hinge to lower cabinet bracket using
original screws.
6. Remove original bottom hinge.
7. Remove two plugs or screws from upper
cabinet bracket.
8. Attach bottom hinge to upper cabinet bracket
using the original screws.
9. Place the door on bottom hinge, tip up to slide
under top hinge.
10. Insert hinge pin into top hinge and door.
11. Tighten hinge pin.
12. Replace screws or plugs into holes left by
hinges.
13. Check action and swing of door.
13. Return kickplate and front service panel to their
original positions and attach to the cabinet using
the original screws.
Page 6
GEMU090
Installation and Use