Use and Care Manual

Click

1. Empty the dust bin first.

2. Turn the robot cleaner

over and place the

bottom facing upright.

3. Unlock left/right fixed clip

of the main brush cover.

4. Separate the brush cover then remove the main brush.

5. Clean the hair or foreign substances stuck on the main brush using the cleaning

brush. After each cleaning session, remove hairs or foreign substances stuck on

the main brush using the cleaning brush. Over time, hairs and fibers accumulate

between the main brush and the bearing. This extra friction makes the cleaning

less efficient, wears the battery out faster, gives shorter run times and can

eventually block the robot. Pull off the main bearing and remove foreign matter.

※ Use scissors or knife along the main brush furrow to remove the hair easily.

※ Note: be careful not to lose the square bearing which is attached to the end of the main brush once you

pull it out for cleaning the main brush.

6. After cleaning, put the

pyramid-shaped bump on the side

of the main brush to the

pyramid-shaped recess on the

drive cam. (Insert firmly to ensure

there is No gap between the brush

and the cam.)

Cleaning Main brush

Furrow

1. While pressing the dust bin's

out button of the main body

as shown in the figure, carefully

separate the dust bin toward the back.

2. Hold the blade of the dust bin as in

the figure, and dust off the litter.

3. Shake the dust bin left/right to

remove the waste inside. Clean the

inner part of the dust bin using

cleaning brush.

4. After closing the blade, hold the dust bin as in the figure, and separate the sterilization filter cover.

5. Dust the filter using cleaning brush.

(cleaning brush is in the charging station. Please open the top cover of docking station)

※ Dust bin can be washed with water. But, completely dry them before assembling and using

them again.

blade

Emptying dust bin and servicing the antibacterial filter

● C A R E & M A I N T E NA N C E