Tuzio® Blenheim Towel Warmer Installation Guide Code: E2013 / E2017 17.75” x 37” Electric Plug-In Technical Helpline: Toll-Free 1-877-757-8990 www.icocanada.
Towel Warmer Installation Procedure 1 Rough-in Requirements (see figure 3) 1. A 110V receptacle located no further than 18” from electric plug-in exit location on towel warmer (see fig. 2), and not above electric plug-in exit location. 2. Wall studs or plywood backing is required in the wall at all bracket locations. See figure 2 for bracket locations. 2 Installation Instructions (see figure 1) 1. Check all items have been received. You should have Towel Warmer and mounting bracket kit.
Specifications & Drawings Model # Description Finish Weight (lb) Element Size Output WxH (mm) WxH (Inches) Metal Type E2013 Blenheim Electric Plug-In Chrome 28.0 300W 1979Btu 450 x 940 17.75” x 37” Mild Steel E2017 Blenheim Electric Plug-In OR Bronze 28.0 300W 1979Btu 450 x 940 17.75” x 37” Mild Steel Heating Element Specifications: 300 watt, 17.75" long, 120 volt, 60 Htz, IP55 cord, ULC approved. Includes 4ft cord and factory fitted plug.
Towel Warmers Electric In-Floor Heating Insulation Board