Installation Guide

Towel Warmer Installation Procedure

1. A 110V receptacle located no further than 18” from electric plug-in exit location on towel warmer (see fig. 2), and not

above electric plug-in exit location.

2. Wall studs or plywood backing is required in the wall at all bracket locations. See figure 2 for bracket locations.

Rough-in Requirements

(see figure 3)

Do not connect the Towel Warmer to the power supply until all instructions have been read and installation carried out in

accord with them. The heating element is 300W 110V. The element conforms to UL standards and the unit to CSA

standards (File ref: 229718). Ensure the CSA label is visible.

1. Turn off power supply.

2. Plug connector in.

3. Switch on power supply again.

Warning: In case of damage or failure of the Towel Warmer the unit should be returned to the

manufacturer or their distributor. The warranty of 1 year on the heating element and 5 years

on the Towel Warmer is NOT VALID in case of improper use or installation. Product is

designed for use within Canada and the United States only.

Installation Instructions

(see figure 1)

1. Check all items have been received. You should have Towel Warmer and mounting bracket kit. Read all instructions

before continuing.

2. Fix wall supports "A" to the wall using the screws provided and in locations as shown on figure 2.

3. Assemble the threaded pin "B", the washer "C", the bush "D" with the threaded head "E", between the second and

third upper and lower tubes of the Towel Warmer.

4. Hang and adjust the Towel Warmer using set screws "F" to lock pin "B" in the wall bracket "A". Ensure the Towel

Warmer is firmly and safely fixed.

Electric Plug-In Connection

fig. 1