User's Manual

98
12
SET MODE
■ Miscellaneous (others) set mode
C
Caalliibbrraattiioonn MMaarrkkeerr
This item is used for a simple frequency check of the
transceiver.
See p. 107 for calibration procedure.
Turn the calibration marker OFF after checking the
frequency of the transceiver.
OONN
Calibration marker ON
OOFFFF
Calibration marker OFF
(default)
BBeeeepp((CCoonnffiirrmmaattiioonn))
A beep sounds each time a switch is pushed to con-
firm it. This function can be turned OFF for silent op-
eration.
The volume level can be set in level set mode. (p. 94)
OONN
Confirmation beep ON
(default)
OOFFFF
Confirmation beep OFF
BBeeeepp((BBaanndd EEddggee))
A beep sounds when an operating frequency enters
or exits an amateur band. This functions independent
of the confirmation beep setting (above).
The volume level can be set in level set mode. (p. 94)
OONN
Band edge beep ON
(default)
OOFFFF
Band edge beep OFF
QQuuiicckk DDuuaallwwaattcchh
When this item is set to ON, pushing [DUALWATCH]
for 1 sec. sets the sub readout frequency to the main
readout frequency and activates dualwatch operation.
See p. 63 for details.
OONN
Quick dualwatch ON
(default)
OOFFFF
Quick dualwatch OFF
QQuuiicckk SSPPLLIITT
When this item is set to ON, pushing [SPLIT] for 1
sec. sets the sub readout frequency to the main read-
out frequency and activates split operation.
See p. 71 for details.
OONN
Quick split ON
(default)
O
OFFFF
Quick split OFF
RRFF//SSQQLL CCoonnttrrooll
The [RF/SQL] control can be set as the RF/squelch
control (default), the squelch control only (RF gain is
fixed at maximum) or ‘Auto’ (RF gain control in SSB,
CW and RTTY; squelch control in AM and FM).
See pgs. 2, 30 for details.
R
RFF++SSQQLL
[RF/SQL] control as RF/squelch control
(default)
S
SQQLL
[RF/SQL] control as squelch control
A
AUUTTOO
[RF/SQL] control as RF gain control in SSB,
CW and RTTY; squelch control in AM and
FM