User's Manual

42
4
RECEIVE AND TRANSMIT
This set mode is used to set the CW side tone, mem-
ory keyer repeat time, dash weight, paddle specifica-
tions, keyer type, etc.
• Setting the electronic keyer
q Push [EXIT/SET] several times, if necessary.
w Push [CW/RTTY] to select CW mode.
e Push [(F-3)KEYER] then [EXIT/SET] to select
keyer set mode.
r Push [(F-4)CW KEY] to select memory keyer set
mode.
t Push [(F-1)∫] or [(F-2)√] to select the desired set
item.
y Set the desired condition using the tuning dial.
•Push [(F-3)DEF] for 1 sec. to select a default condition
or value.
u Push [EXIT/SET] twice to normal screen.
DEFDEF
KEYER CW-KEYKEYER CW-KEY
é
è
KeyerKeyer RepeatRepeatTimeTime 2s 2s
Dot/DashDot/Dash RatioRatio 1:1:3.01:1:3.0
Rise
RiseTimeTime 4ms4ms
Paddle
PaddlePolarityPolarity NormalNormal
Keyer
KeyerTypeType ELEC-KEYELEC-KEY
MIC
MICUp/DownUp/Down KeyerKeyer OFFOFF
AGCAGC
MID
MID
1/41/4
OFF
OFF
BK-INBK-IN
OFF
OFF
[(F-2)√][(F-1)∫] [EXIT/SET]
[(F-3)DEL]
DD
Keyer set mode
Keyer Repeat Time
(Keyer repeat time)
When sending CW using the repeat timer, this item
sets the time between transmission.
•1 to 60 sec. in 1 sec. steps can be selected.
(default: 2 sec.)
Dot/Dash Ratio (Dot/Dash ratio)
This item sets the dot/dash ratio.
•1:1:2.8 to 1 : 1 : 4.5 can be set.
• Check the ratio with side tone in CW mode.
• Push [(F-3)DEF] to select a default ratio of 1 : 1 : 3.0.
Keying weight example: Morse code “K”
DASH
Weight setting:
1:1:3 (default)
Weight setting:
Adjusted
DASH
DOT (Fixed*)
Adjustable range SPACE (Fixed*)
*SPACE and DOT length can be adjusted with
[KEY SPEED] only.