User's Manual

69
6
FUNCTION FOR TRANSMIT
■ Monitor function
The monitor function allows you to monitor your trans-
mit IF signals in any mode through the speaker. Use
this to check voice characteristics while adjusting
SSB transmit tones. (p. 93) The CW sidetone func-
tions regardless of the [MONITOR] switch setting.
q Push [MONITOR].
•The indicator lights when the monitor function is ON.
w Push [EXIT/SET] several times to close a multi-
function screen, if necessary.
e Push [EXIT/SET] for 1 sec. then [(F-1)LEVEL] to
enter level set mode.
r Push [(F-1)Y] or [(F-2)Z] to select the monitor
level item.
t Adjust monitor gain using the tuning dial.
•Pushing [(F-3)DEF] sets the selected item to the default
value of the item.
y Push [EXIT/SET] twice to exit level set mode.
•Use headphones to prevent feedback.
•Set the transmit tone settings to the 0 dB positions
to check the unaltered characteristics of transmit-
ter or microphone.
BWBW
2.4k2.4k
SFTSFT
0
FIL2FIL2
USBUSB
qw:pp
TXTX
VFOVFO
USBUSB
USBUSB
USB
USB
FIL2
FIL2
q r .q o t .p p
q r .w p t .p p
14.100.0014.100.00
14.100.00
14.100.00
1
1
VFOVFO
é
è
DEF
LEVEL SET
ANTANT
1
COMPCOMP
OFF
OFF
WIDE
WIDE
METERMETER
Po
Po
P.AMPP.AMP
1
AGCAGC
MID
MID
ATTATT
OFF
OFF
VOXVOX
OFF
OFF
SSBTBW(NAR) L 500
SSBTBW(NAR) H 2500
MonitorLevel 50%
SideToneLevel 50%
SideToneLevelLimit ON
BeepLevel 50%
BeepLevelLimit ON
[MONITOR] switch
[PHONES]
jack