User Guide

24
5
MEMORY OPERATION
4
5
■ General description
The transceiver has 207 memory channels including 6 scan
edge memory channels (3 pairs), and 1 call channel. Each of
these channels can be individually programmed with operat-
ing frequency (pgs. 9, 10), duplex direction (p. 17) and offset
(p. 21), subaudible tone encoder or tone squelch and its tone
frequency (pgs. 19, 48–50) and skip information* (p. 41).
In addition, a total of 10 memory banks, A to J, are available
for usage by group, etc.
*except for scan edge memory channels.
■ Memory channel selection
D Using the tuning dial
q Push [M/CALL ]
once or twice to select
memory mode.
•“M” indicator appears.
w Rotate [DIAL] to select
the desired memory
channel.
• Programmed memory
channels only can be se-
lected.
D Using the [Y]/[Z] keys
z Push [MR/CALL] to select memory mode.
x Push [
YY
] or [
ZZ
] to select and set the desired
memory channel.
• Pushing [
YY
]/[
ZZ
] for 1 sec. activates a scan.
• If scan is activated, push [
YY
]/[
ZZ
] again or push
[ CLR A(MW)] to stop it.
D Using the keypad
z Push [MR/CALL] to select memory mode.
x Push [
ENT C(T-OFF)] to activate the keypad
for numeral input.
c Push 3 appropriate digit keys to input a chan-
nel number.
• When inputting non-programmed channel num-
bers, the previous memory channel appears.
• Push only 1 appropriate digit key, [ MONI 1(ANM)],
[ SCAN 2(T-SCAN)] or [ PRIO 3(PTT-M)], then push
[
MM
(TONE-1)] or [ SQL
ZZ
#(16KEY-L)] to select scan
edge channels. “
MM
” and “#” can be used for “A”
and “b” respectively.
MR/CALL
Y/Z
MR/CALL
Y/Z
PRIO
LOCK
S E T
ANM
MONI
DUP
LOW
T
-
SCAN
TONE
PRIO
M/CALL
SCAN
V/MHz
DIGITAL
PRIO
AO
BUSY
MUTE
NAR
MID
LOW
[DIAL]
Appears