User Guide

56
11
PAGER/CODE SQUELCH
11
D Waiting for a call from a specific station
q Set the operating frequency.
w Push [BANK ] for 1 sec then rotate [DIAL] to turn
Pager mode ON.
• 100 MHz digit shows “P.”
e Wait for a call.
• When receiving a call, the caller’s ID or group code appears as
shown at right.
r Push [PTT] to send an answer back call and display the
operating frequency.
t After confirming a connection, push [BANK ] for
1 sec. then rotate [DIAL] to select code squelch operation,
or repeat the previous key operation again to select non-
selective calling system.
z Set the operating frequency.
x Push [BANK/OPTION] for 1 sec. then
push [
YY
]/[
ZZ
] to turn Pager mode ON.
• 100 MHz digit shows “P.”
c Wait for a call.
• When receiving a call, the caller’s ID or group
code appears as shown at right.
• DO NOT push any digit keys while code chan-
nels C0 to C6 are displayed, or code channel
contents will be changed.
v Push [PTT] to send an answer back call
and display the operating frequency.
b After confirming a connection, push
[BANK/OPTION] for 1 sec. to select code
squelch operation, or repeat the previous
key operation again to select non-selective
calling system.
• PERSONAL CALLS
This display appears when
you are called with your ID
code and the calling station’s
ID code is 424.
• GROUP CALLS
This display appears when
you are called with the group
code, 888, and 888 has been
programmed into code chan-
nel C6.
• ERROR INFORMATION
When the transceiver re-
ceives an incomplete signal,
“E” and previously received
code appear.
LOCK
S E T
ANM
MONI
DUP
LOW
T
-
SCAN
TONE
PRIO
M/CALL
SCAN
V/MHz
DIGITAL
PRIO
AO
BUSY
MUTE
NAR
MID
LOW
Previously received code.
LOCK
S E T
ANM
MONI
DUP
LOW
T
-
SCAN
TONE
PRIO
M/CALL
SCAN
V/MHz
DIGITAL
PRIO
AO
BUSY
MUTE
NAR
MID
LOW
Code channel
LOCK
S E T
ANM
MONI
DUP
LOW
T
-
SCAN
TONE
PRIO
M/CALL
SCAN
V/MHz
DIGITAL
PRIO
AO
BUSY
MUTE
NAR
MID
LOW
CP and blink.
BANK/OPTION
OPT
OPT