User's Manual Part 4

9-6
■ Memory scan operation
q Push [EXIT/SET] several times to close a multi-func-
tion screen, if necessary.
w Select memory mode.
e Push [F-5•SCAN] to select the scan screen.
r Set the main band’s [SQL] open or closed.
• See page 9-2 for squelch condition.
t Push [F-1•MEMO] to start the memory scan.
• “ ” and decimal points blink while scan-
ning.
y When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume set-
ting and the squelch condition.
u To cancel the scan, push [F-1•MEMO].
• Rotating the main dial also cancels the scan.
2 or more memory channels must be programmed
for memory scan to start.
■ Select memory scan operation
q Push [EXIT/SET] several times to close a multi-func-
tion screen, if necessary.
w Select memory mode.
e Push [F-5•SCAN] to select the scan screen.
r Set the main band’s [SQL] open or closed.
• See page 9-2 for squelch condition.
t Push [F-5•SEL No.] several times to select the se-
lect scan number from ★1, ★2, ★3 and ★1/★2/★3.
y Push [F-1•MEMO] to start the memory scan.
• “ ” and decimal points blink while scan-
ning.
u Push [F-3•SELECT] to start select memory scan;
push [F-3•SELECT] again to return to memory scan,
if desired.
• “ ” blinks instead of
“ ” during select memory scan.
i When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume set-
ting and the squelch condition.
o To cancel the scan, push [F-1•MEMO].
• Rotating the main dial also cancels the scan.
2 or more memory channels must be designated as
select memory channels, as well as the same select
scan number, for select memory scan to start.
[SQL] for main [F-1•MEMO]
[F-3•SELECT]
[F-5•SEL No.]
[EXIT/SET] Main dial
[SQL] for main [F-1•MEMO] [EXIT/SET] Main dial
9
SCANS