User's Manual Part 4

8-4
■ Memory channel programming
Memory channel programming can be preformed ei-
ther in VFO mode or in memory mode.
D
Programming in VFO mode
q Set the desired frequency, operating mode and fil-
ter width in VFO mode.
w Push [Y]/[Z] several times to select the desired
memory channel.
• Memory list screen is convenient for selecting the de-
sired channel.
• Memory channel contents appear in the memory chan-
nel readout (below the frequency readout).
• “--.---.--” appears if the selected memory channel is a
blank channel (and does not have contents).
e Push [MW] for 1 sec. to program the displayed fre-
quency and operating mode into the memory chan-
nel.
D
Programming in memory mode
q Select the desired memory channel with [Y]/[Z] in
memory mode.
• Memory channel contents appear in the memory chan-
nel readout (below the frequency readout).
• “--.---.--” appears if the selected memory channel is a
blank channel (and does not have contents).
w Set the desired frequency and operating mode in
memory mode.
• To program a blank channel, use direct frequency entry
with the keypad or memo pads, etc.
e Push [MW] for 1 sec. to program the displayed fre-
quency and operating mode into the memory chan-
nel.
[Y] [Z] [MW]
8
MEMORY OPERATION
or
Push for 1 sec.
Beep
Beep
Beep
[EXAMPLE]: Programming 7.088 MHz/LSB into memory
channel 12.
or then
Push for 1 sec.
Beep
Beep
Beep
[EXAMPLE]: Programming 21.280 MHz/USB into memory
channel 18.