User Manual

15
7
TROUBLESHOOTING
6
7
PROBLEM POSSIBLE CAUSE SOLUTION REF.
No sound from speaker. • Squelch level is too deep.
• Volume level is too low.
• Speaker has been exposed to water.
p. 7
p. 7
—
• Set squelch to the threshold point.
• Set [VOL] to a suitable level.
• Drain water from the speaker.
The transceiver does
not turn ON.
• Bad connection to the battery pack. p. ?• Check the connection to the transceiver.
Transmitting is impossi-
ble, or high power can
not be selected.
• Some channels are for low power or re-
ceive only.
• The output power is set to low.
pgs. 5,
6, 16
p. 7
• Change channels.
• Push [HI/LO] on the microphone to select
high power.
Scan does not start. •“TAG” channels are not programmed. • Set the desired channels as “TAG” channels. p. 11
No beeps. • Beep tones are turned OFF.
• The squelch is open.
• Turn the beep tone ON in SET mode.
• Set squelch to the threshold point.
p. 14
p. 7
Distress call cannot be
transmitted.
• MMSI (DSC self ID) code is not pro-
grammed.
• Program the MMSI (DSC self ID) code. p. ?
!IC-M302_draft.qxd 03.9.1 6:02 PM Page 15 (1,1)