User's Manual

7
2
INSTALLATION AND CONNECTIONS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
q Put the scanner unit on the stay, then attach the an-
tenna rotor with the supplied bolts (M8×18 mm), flat
and belleville washers and a sealing washer.
Be sure to install the belleville washer in the direc-
tion as shown below. (Fig. 1)
w Apply the lubricant specified below, or an equivalent
one, to the motor bearing, if required.
• Manufacture : ESSO
Type : BEACON 325
e Connect the grounding wire (purchase locally) to the
ground plate with the supplied terminal if required.
(Fig. 2)
NOTE: When using the optional system cable.
Peel the outer sheath of the system cable when
using the optional system cable OPC-1078.
BE CAREFUL! DO NOT cut the inner shield wire when
peeling the outer sheath.
Unit: mm (inch)
� �
Peel the sheath
To the displayTo the scanner
■ Attaching the EX-2780 scanner unit
Scanner unit
Stay
Sealing washer
Flat washer
Belleville washer
(Install in this direction)
Bolt
Lubrication fitting place
Grounding wire
Fig.1
Fig.2
18±2
(
23
⁄32±
3
⁄32)
410±5
(16
5
⁄32±
3
⁄16)
MXR-5000T / Page 13-1-11