User's Manual

i
Icom, Icom Inc. and the Icom logo are registered trademarks of
Icom Incorporated (Japan) in Japan, the United States, the United
Kingdom, Germany, France, Spain, Russia and/or other countries.
MarineCommander is a trademark of Icom Incorporated.
All other products or brands are registered trademarks or trade-
marks of their respective holders.
PRECAUTIONS
R WARNING! NEVER let metal, wire or other
objects touch any internal part or terminals of the
Main unit. This may result in an electric shock.
R WARNING! NEVER apply AC voltage to the
DC input terminals of the Main unit. This may pose a
fire hazard, result in an electric shock or damage the
Main unit.
R WARNING! NEVER apply more than 32 V
DC to the DC input terminals of the Main unit or
use reverse polarity. This may pose a fire hazard or
damage the Main unit.
R WARNING! NEVER cut the DC power cable
between the DC plug and fuse holder. If an incorrect
connection is made after cutting, the Main unit may
be damaged.
R WARNING! NEVER touch the Main unit with
wet hands. This may result in an electric shock or
damage the Main unit.
R WARNING! NEVER open the bottom cover of
the Main unit. There are no user adjustment points.
This may result in an electric shock and incorrect
reassembly may cause a fire hazard.
DO NOT place the Main unit in excessively dusty
environments.
DO NOT place the Main unit near heating
equipment or in direct sunlight or where hot or cold air
blows directly onto it.
DO NOT use or place the Main unit in areas with
temperature below –20˚C (–4˚F) or above +60˚C
(+140˚F).
DO NOT place the Main unit in areas that will block
air passage or put anything around the Main unit. This
will obstruct heat dissipation.
DO NOT use harsh solvent such as benzine or
alcohol to clean the Main unit, as they will damage
the Main unit’s surfaces.
KEEP the Main unit out of the reach of children.
KEEP the Main unit away from heavy rain, and never
immerse it in the water.
The Main unit meets IPX4 requirements for splash
resistance when the supplied connection cables are
connected, and the connector cap is installed on the
other connector.
However, if it is dropped, splash resistance cannot be
guaranteed because of possible damage to the case
or the waterproof seals.
MXR-5000T / Page 13-2-2