Instruction Manual

42
8
MENU SCREEN
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
■ AIS menu
Display (Default: ON)
Turns the AIS Display function ON or OFF when the
MR-1010RII is in Transmitting (TX) mode.
• OFF: Turns OFF the AIS display.
• ON: Turns ON the AIS display.
NOTE: If an AIS target reaches the CPA and
TCPA limits when “OFF” is selected, this setting is
automatically turned ON.
Track (Default: OFF)
The plot displays the AIS target’s past positions as 5
dots,duringeachspeciedtrackinginterval.
You can specify the track interval in the “Track
Interval” item of the Target menu.
• OFF: Turns OFF the Track display function.
• ON: Turns ON the Track display function.
Name Display (Default: OFF)
Selects the AIS target display type.
• OFF: Does not display any name or MMSI
number of the target.
• Select: Displays the vessel name or MMSI
number of the selected target.
• Active: Displays the vessel name or MMSI
number of all active targets.
Auto Activate (Default: ON)
The Auto Activate function automatically changes the
sleeping AIS target to an activated target when the
AIStargetisatthespecieddistanceandangle.
You can specify the distance and angle in the next
two items.
• OFF: Turns OFF the Auto Activate function.
• ON: Turns ON the Auto Activate function.
Auto Activate - Distance (Default: 1.0 NM)
Sets the distance to automatically changes the
sleeping AIS target to an activated target.
• 0.1 to 10.0 NM:
Select the distance from your vessel.
Auto Activate - Angle (Default: ±180°)
Sets the angle to automatically change the sleeping
AIS target to an activated target.
• 5 to 180°: Select the angle with your vessel.
New Target Warning (Default: OFF)
Sets whether the MR-1010RII gives a warning when
the Auto Activate function automatically changes the
sleeping AIS target to an activated target, or not.
• OFF: Does not give a warning when the Auto
Activate function activates the target.
• ON: Gives a warning when the Auto Activate
function activates the target.
Display Range (Default: 8.0 NM)
Sets the AIS targets display range to between 0.1
and 36.0 NM, or
∞.
• 0.1 to 36.0 NM: Select the range from your vessel in
0.1 NM steps.
• ∞: Displays all ranges from your
vessel.
Number of AIS (Default: 100)
Selects the maximum number of AIS targets that can
be displayed on the screen to between 10 and 100 in
1 target steps.
Slow Warn (Default: ON)
The AIS unit calculated Course Over Ground (COG)
data of a vessel that is at anchor or drifting is
unreliable, and therefore Closest Point of Approach
(CPA) and Time to CPA (TCPA) data may not be
correctly calculated. If a vessel is anchored in your
alarm zone, the unreliable data can cause the
collision alarm to sound many times, even if there is
no real danger. To prevent this, when the anchored
vessel’s Speed Over Ground (COG) is less than
this set value, the Slow Warn function assumes that
vessel’sCOGisxedtowardsyourvesselandan
alarm will sound.
• OFF: Turns OFF the Slow Warn function.
• ON: Turns ON the Slow Warn function.
Slow Warn Speed (Default: 0.1 kn)
• 0.1 to 5.0 kn: Selects the vessel’s speed in 0.1 kn
steps.
MR-1010RII / Page 13-47