Instruction Manual

59
INSTALLATION AND CONNECTIONS
14
■ Installing the UX-252 Video output unit
When an optional UX-252 is installed, the MR-1010RII
can be connected to an external display or a PC
monitor with a VGA connector.
L The monitor requires the resolution of 640 × 480 or
higher.
R WARNING! BE SURE to disconnect the
power cable from the display unit, when you are
installing the optional unit.
1. Remove the cable hole seal on the left of the
serial number label of the display unit. (Fig. 1)
R DANGER! NEVER use your nger nail to
remove the seal. Otherwise, you may injure
your nail.
2. Remove the 12 screws from the display unit’s
rear panel. (Fig. 1)
3. Slowly open the rear case and disconnect the
four connectors from the display’s main board.
(Fig. 1)
CAUTION: DO NOT pull the cables when
opening the rear case. This could damage the
cables and/or display unit.
L One of the connectors has a lock. Hold the release
on connector head to disconnect the connector.
4. Pass the video output cable through the hole,
then screw in and tighten the sealing tube.
(Fig. 2)
5. Connect the video output cable to the connector
on the UX-252. (Fig. 3)
Cable hole
seal
Scre
w
Fig. 1
Video output cable
UX-252
Fig. 3
Video output cable
Sealing tube
Sealing nut
Washer
Fig. 2
MR-1010RII / Page 13-64