User's Manual

8
3
BASIC OPERATION
■ Turning power ON
q Rotate [VOL] to turn the power ON.
w If the transceiver is programmed for a start up passcode,
input the digit codes as directed by your dealer.
 •Thekeysinthetablebelowcanbeusedforpasswordinput:
 •Thetransceiverdetectsnumbersinthesameblockasidentical.
Therefore“01234”and“56789”arethesame.
eWhenthe“PASSWORD”indicationdoesnotclearafterin-
putting 4 digits, the input code number may be incorrect.
Turn the power off and start over in this case.
■ Channel selection
Push [UP] or [DOWN], or rotate [ROTARY SELECTOR]
to select the desired system channel or talk group, in se-
quence.
•Upto16pre-programmedchannelscanbeselectedvia[ROTARY
SELECTOR].
■ Call procedure
When your system employs tone signalling (excluding
CTCSS and DTCS), the call procedure may be necessary
prior to voice transmission. The tone signalling employed may
be a selective calling system which allows you to call specific
station(s) only and prevent unwanted stations from contact-
ing you.
q Select the desired DTMF encode channel according to
yourSystemOperator’sinstructions.
 •Thismaynotbenecessarydependingonprogramming.
 •Refertopages10,13or15forselection.
w Push the [PTT].
e After transmitting a DTMF code, the remainder of your
communication can be carried out in the normal fashion.
Selective calling
Non-selective calling
KEY
NUMBER
0
5
4
9
3
8
2
7
1
6
UP