User Manual

BIIS OPERATION

Direct code entry

q While in the standby condition, push [P3] (TX Code Enter)

to enter the TX code edit mode.

• Editable code digit blinks.

w Push [P3] (TX Code Enter) to select the desired digit to be

edited.

• Editable digit differs according to the setting.

e Set the desired digit using [CH Up]/[CH Down]/[DIAL] or

10-keypad*.

*IC-F1821/D or IC-F2821/D only

r Push [P3] (TX Code Enter) to set the digit, then the

editable digit will move to the right automatically.

• When the 10-keypad is used to set, the editable digit will move to

the right automatically without pushing [P3] (TX Code Enter).

t Repeat e and r to input all allowable digits.

y Push [P0] (Call) or [PTT]* to call.

*PTT call can be made only when PTT call capability is permitted.

NOTE: When no answer back is received, the trans-

ceiver repeats the call 3 times (default) automatically,

and

“WAIT” is displayed during each call. However, an

error beep sounds and

“FAILED” is displayed when no

answer back is received after the calls.

u Push [PTT] to transmit; release to receive.

i Push [P4] (Moni(Audi)) to send the ‘Clear down’ signal.

For your information

When the “UpDate” setting for the call code is enabled, the

set code is overwritten into the call code memory.

0500

!IC-F1721D.qxd 04.9.2 5:58 PM Page 17 (1,1)