User's Manual Part 1

4
1
PANEL DESCRIPTION
1
rAUTO POWER-OFF INDICATOR (p. 62)
Appears while the auto power OFF function is in use.
tAUDIO MUTE INDICATOR (P. 18)
Appears when the audio mute function is activated.
• The mute can only be switched ON and OFF from the HM-133
only.
yFREQUENCY READOUT
Shows the operating frequency, channel names, set mode
contents, etc.
• Frequency decimal point blinks while scanning. (p. 41)
• “d” appears in place of the 1st digit while the DTMF memory
function is in use. (p. 48)
uMEMORY INDICATOR (pgs. 11, 26)
Appears when memory mode is selected.
iWEATHER ALERT INDICATOR (p. 66)
Appears when the weather alert function is activated.
• The either alert function is available with the USA version only.
1oPRIORITY INDICATOR (p. 47)
Appears while the priority watch is activated; blinks while
the watch is paused.
!0MEMORY CHANNEL NUMBER INDICATORS
➥ Shows the selected memory channel number. (p. 26)
➥ Shows the selected bank initial. (p. 35)
➥ “C” appears when the call channel is selected. (p. 38)
➥ “L” appears when the lock function is activated. (p. 14)
!1SKIP INDICATORS (p. 44)
➥ “~”appears when the displayed memory channel is
specified as a skip channel.
➥ “P ~” appears when the displayed frequency is spec-
ified as a program skip frequency.
!2SQUELCH ATTENUATOR INDICATOR (p. 16)
Appears when the squelch attenuator function is activated.
• The attenuator can be switched OFF in initial set mode. (p. 63)
!3DIGITAL MESSAGE INDICATOR (p. 61)
Appears when a digital message is received.
!4MODE INDICATORS
➥ No indication appears while in the FM mode operation.
(p. 65)
➥ “AM” appears while in the AM mode operation. (p. 65)
➥ “NAR” appears while in the FM/AM narrow mode oper-
ation. (p. 65)
➥ “DV” appears while in the digital mode operation. (p.
??)
• Blinking all indication indicates the FM mode selection while
setting.
!5S/RF INDICATORS
➥ Shows the relative signal strength while receiving sig-
nals. (p. 15)
➥ Shows the output power level while transmitting. (p. 17)
!6OUTPUT POWER INDICATORS
“LOW” appears when low output power; “MID” appears
when middle output power is selected.
No indicator appears when high output power is selected.
!7BUSY INDICATOR
➥ Appears when a signal is being received or the squelch
is open. (p. 15)
➥ Blinks while the monitor function is activated. (p. 15)