User's Manual

PANEL DESCRIPTION

o 10-KEYPAD (IC-F70DT/F70T or IC-F80DT/F80T only)

The keypad allows you to enter digits to:

• Select memory channels, tone channels and DTMF codes

(when in the DTMF code channel selection mode)

• Set TX codes and BIIS status number

• Input text message for SDM operation

• Start up with a password

• Input the Individual ID code for digital operation.

!0 MONITOR SWITCH

➥ Mute and release the CTCSS (DTCS) or 2-tone squelch

mute. Open any squelch/deactivate any mute while

pushing this key. (LMR operation only)

➥ Activates one of (or two of) the following functions on

each channel independently.

(PMR or BIIS PMR operation only)

• Push and hold the key to unmute the channel (audio is

emitted; ‘audible’ condition).

• Push the key to toggle the mute and unmute conditions

(toggles ‘audible’ and ‘inaudible’).

• Push the key to mute the channel (sets to ‘inaudible’ only).

• Push the key to unmute the channel (sets to ‘audible’ only).

• Push the key after communication is ﬁnished to send a ‘reset

code.’

• Push the key after communication is ﬁnished to send a ‘clear

down code’ during BIIS operation on an MSK channel.

NOTE: The unmute condition (‘audible’ conditions)

may automatically return to the mute condition

(‘inaudible’ condition) after a speciﬁed period.

*Desired function can be programmed by your dealer. (p. 7)

!1 PTT SWITCH [PTT]

➥ Push and hold to transmit; release to receive.

➥ Push to transmit the call during MSK operation, depend-

ing on the setting.

!2 UP/DOWN SWITCHES

➥ Push to select an operating channel.

➥ Push to select a TX code channel after pushing

[TX CODE CH SELECT].

➥ Push to select a DTMF channel after pushing [DTMF].

➥ Push to select a scan group after pushing and holding

[SCAN].

➥ Push to select a BIIS code, status number or SDM after

pushing [DIGITAL].

*Desired functions can be programmed independently by your

dealer. (p. 7)

!IC-F70_F80.qxd 04.11.9 0:01 PM Page 5 (1,1)