User's Manual Part 1

PANEL DESCRIPTION

❍ While in the digital (DV) mode operation with the in-

stalling an optional Digital unit UT-118.

➥ “” appears while the digital code (CSQL) squelch

function is in use. (p. 47)

➥ “” appears while the call sign (DSQL) squelch func-

tion is in use. (p. 47)

➥ “” appears with the “ ” or “ ” indicator while the

pocket beep function (CSQL or DSQL) is in use.

(p. 46)

y TRANSMIT INDICATOR (p. 15)

Appears during transmit.

u FREQUENCY READOUT

Shows operating frequency, channel number or channel

names, depending on display type (p. 16).

i SIGNAL INDICATOR

➥ Shows receiving signal strength as below.

➥ Shows the output power level while transmitting.

o BUSY INDICATOR

➥ Appears when a signal is being received or the squelch

is open.

➥ Blinks while the monitor function is activated. (pgs.15,

47)

!0 PAGER CALL INDICATOR (p. 39)

Blinks when a pager call is received. (This indicator ap-

pears only when UT-108 is installed.)

!1 DIGITAL MODE INDICATOR (p. 43)

Appears when digital mode is selected. (This indicator ap-

pears only when UT-118 is installed.)

!2 LOW/MIDDLE POWER INDICATOR (p. 15)

➥ “L” or “M” appears when the low or middle output power

is selected, respectively.

➥ No indicator appears when high output power is se-

lected.

!3 SKIP CHANNEL INDICATOR (p. 30)

Appears when the selected memory channel is speciﬁed

as a skip channel.

!4MEMORY MODE INDICATOR (p. 20)

Appears while in memory mode or channel number indica-

tion mode.

!5MEMORY CHANNEL INDICATOR (p. 20)

➥ Shows the selected memory channel number.

➥ “C” appears when the call channel is selected.

Low Middle High

Weak ⇐ RX Signal level ⇒ Strong