Manualshelf

User's Manual Part 1

ManualsBrandsICOM ManualsElectronicsVHF Scanning Receiver
31323334353637383940
28
SCAN OPERATION
8
■ Programmed scan
Programmed scan repeatedly scans between two user pro-
grammed frequencies (memory channels “1A–3A” and
“1b–3b”) or scans between upper and lower band edges. This
scan is useful for checking for signals within a specific fre-
quency range such as repeater output frequencies, etc.
Scans between lower (start) and high (stop) frequency.
qPush [D•
CLR
] to select VFO mode, if necessary.
wPush [A•
FUNC
] and [5•
SCAN
] to start the scan, then a se-
lected scan edge appears as “P1,” “P2,” “P3” or “AL.”
•To change the scan edge, push [A•
FUNC
] and [8•
SET
] several
times until the desired scan edge appears.
• “AL” for full scan, “P1”, “P2” and “P3” for programmed scan be-
tween the programmed scan edge channels as “1A”–“1b,”
“2A”–“2b” and “3A”–“3b.”
•To change the scan direction, push [
Y
Y
] or [
ZZ
].
• When [VOL] is assigned as tuning dial, rotate [VOL] to change
the scan direction. (pgs. 14, 63)
ePush [D•
CLR
] to stop the scan.
Push
SCAN
FUNC
A
5
■ Scan types