User's Manual Part 1

29
8
SCAN OPERATION
8
NOTE: Scan edges, 1A–3A/1b–3b, must be programmed
in advance. Program them in the same manner as regular
memory channels. (p. 21)
If the same frequencies are programmed into the scan
edges, programmed scan will not proceed.
■ Memory scan
Memory scan repeatedly scans all programmed memory
channels, except those set as skip channels.
qPush [C•
MR ] to select memory mode, if necessary.
•“
X
” appears.
wPush [A• FUNC ] and [5• SCAN ] to start the scan.
•To change the scan direction, push [
Y
Y
] or [
ZZ
].
• When [VOL] is assigned as tuning dial, rotate [VOL] to change
the scan direction. (pgs. 14, 63)
e Push [D•
CLR ] to stop the scan.
• Bank scan —Select the desired bank at above step q.
q Push [A•
FUNC ] and [#• BANK ] to select memory bank con-
dition.
w Rotate [VOL] to select the desired bank, A to J.
e Push [✱•
ENT ] (or [D• CLR ]) to set the bank.
Push
SCAN
FUNC
A
5
MONI
CALL
DUP SCAN
PRIO
ENT SET H/M/L
OPTSKIP
BANK TONE T.SCANP.BEEP
MR CLRFUNC
PWR
987
4
123
AB DC
560