User's Manual Part 2

■ Digital mode operation
The IC-V82 with optional digital unit UT-118 can be operated
for digital voice mode and low-speed data operation for both
transmit and receive. Also available for connecting GPS re-
ceiver (compatible with an RS-232C output/NMEA for-
mat/4800 bps) and transmit/receive position data.
■ Call sign programming
Four kind of call sign memories are available for your own call
sign “myC,” other station call sign “yUC” and nearest repeater
call sign “R1C” and another zone’s repeater call sign “R2C.”
Each call sign memory can be stored up to 6 call signs, and
each call sign programmed up to 8 characters.
D
D
Your call sign programming
Your call sign must be programmed for both Digital voice and
low-speed data communications (including GPS transmis-
sion).
q Push [A•
FUNC ] and [0• OPT ] to enter OPTION SET MODE , then
push [
Y
Y
] or [
ZZ
] several times to select the call sign select
mode.
• “myC” appears.
w Push [0•
OPT ] for 1 sec. then rotate [VOL] to select the de-
sired call sign channel.
e Push [
Y
Y
] (or [
ZZ
]) to set into call sign programming condi-
tion.
• The 1st digit blinks and channel indication stops blinking.
r Rotate [VOL] to set the desired character or code.
• Push [
Z
Z
] or [
YY
] to move the cursor to left or right, respectively.
t Push [
Y
Y
] (or [
ZZ
]) to select 2nd digit, then rotate [VOL] to
set the desired character or code.
• 2nd digit blinks (1st digit stops blinking).
• Repeat this step for programming your call sign.
y Push [0•
OPT ] to fix the call sign.
u Rotate [VOL] to select an another channel from “C1” to
“C6.”
i Repeat steps w to u to program your call sign channels.
40
DIGITAL MODE OPERATION
11
Required Optional UT-118