User's Manual Part 2

67
12
OTHER FUNCTIONS
12
q Select the desired weather channel.
w Turn the weather alert function ON in set mode.
➥ Push [A• FUNC ] and [8• SET ] to enter SET MODE .
➥ Push [
Y
Y
]
or [
Z
Z
] to select the weather alert item, then
rotate [VOL] to set ON.
➥ push [✱•
ENT ] (or [D• CLR ]) to exit SET MODE .
e Sets the desired stand-by condition.
• Selects VFO, memory or call channel.
• Scan or priority watch operation can also be selected.
r When the alert is detected, a beep sounds and the follow-
ing indication will be displayed.
t Turn the weather alert function OFF in
SET MODE .
☞ NOTE: While receiving a signal (on a frequency other than
the weather alert ON frequency), the receiving signal or
audio will be interrupted momentarily every 5 sec. (approx.)
in case the alert function is turned ON. This symptom is
caused by the WX alert function. To cancel these symp-
toms, set the weather alert item OFF in
SET MODE .
■ CPU reset
The function display may occasionally
display erroneous information (e.g. when
first applying power). This may be
caused externally by static electricity or
other factors.
If this problem occurs, turn power OFF.
After waiting a few seconds, turn power
ON again. If the problem persists, per-
form CPU resetting operation as follows.
• While pushing [MONI] and [D•
CLR ],
turn power ON.
CAUTION:
Resetting the CPU returns the radio to factory default settings.
■ Partial reset
If you want to initialize the operating
conditions (VFO frequency, VFO set-
tings, set mode contents) without
clearing the memory contents, a par-
tial resetting function is available for
the transceiver.
• While pushing [D•
CLR ], turn the
power ON to partially reset the
transceiver.
AT POWER ON
AT POWER ON
Shows above indications alternately.
PWR
MONI
CLR
D
PWR
CLR
D