User's Manual Part 2

Cloning allows you to quickly and easily transfer the pro-

grammed contents from one transceiver to another trans-

ceiver.

D Transceiver-to-transceiver cloning

q Connect the OPC-474

CLONING CABLE

to the [SP] jack of

the master and sub-transceivers.

• The master transceiver is used to send data to the sub-trans-

ceiver.

w While pushing [A•

FUNC

] and [

turn power ON to enter cloning

mode (master transceiver only—

power ON only for sub-transceiver).

• “CLONE” appears and the transceivers

enter the clone standby condition.

e Push [PTT] on the master transceiver.

• “CL OU” appears in the master transceiver’s display and S-meter

indicator shows that data is being transferred to the sub-trans-

ceiver.

• “CL IN” appears automatically in the sub-transceiver’s display

and S-meter indicator shows that data is being received from the

master transceiver.

r When cloning is ﬁnished, turn power OFF, then ON again

to exit cloning mode.

D Cloning using a PC

Please refer to the HELP file that comes with CS-V82

CLONING SOFTWARE

NOTE: DO NOT push the [PTT] on the sub-transceiver

during cloning. This will cause a cloning error.

TRANSCEIVER

to USB port

to RS-232C port

OPC-478 (RS-232C type)

OPC-478U (USB type)

PWR

FUNC

POWER ON

CLONING