User's Manual Part 2

37
10
PAGER/CODE SQUELCH
10
DD
Code programming
An ID code MUST be programmed into code channel C0. Up
to 6 transmit codes are programmable into code channels, C1
to C6, if required.
q Push [A•
FUNC ], then push [0• OPT ] to enter OPTION SET
MODE .
• Rotate [VOL] to select “dtm.PG” or “dtm.CS,” if “dtm.OF” ap-
pears.
w Push [0• OPT ] for 1 sec. to enter the code selection mode.
• One of either “CP” or “C0” to “C6” blinks.
• “C0” is the ID code and “C1” to “C6” are transmit codes.
e Rotate [VOL] (or push [
Y
Y
]/[
ZZ
]) to select code channel C0.
•Adifferent ID code must be programmed into each transceiver.
r Enter the desired 3-digit ID code via the keypad.
t Rotate [VOL] (or push [
Y
Y
]/[
ZZ
]) to select a transmit code
channel from C1 to C6.
y Enter the desired 3-digit transmit code via the keypad.
u Push [A•
FUNC ], then push [6• SKIP ] to set the channel for
“receive inhibit” or “receive accept.”
• When “receive inhibit” is set, “SKIP” appears as below.
• Code channel C0 cannot be set as “receive inhibit.”
• See the table for “receive accept” and “receive inhibit” details
(p. 36).
i Repeat steps t and y to set additional transmit code
channels, if desired.
o Push [✱• ENT ] or [PTT] to exit CODE SET MODE .
•Receive accept/receive inhibit
➥ “Receive accept” (“SKIP” indicator does not appear) ac-
cepts pager calls when the transceiver receives a signal
with a code the same as that in the code channel.
➥ “Receive inhibit” (“SKIP” indicator appears) rejects calls
even when the transceiver receives a code the same as
that in the code channel. Transmit codes should therefore
be programmed for “receive inhibit,” otherwise the trans-
ceiver will not reject unnecessary calls.
or