User's Manual Part 2

38
10
PAGER/CODE SQUELCH
■ Pager operation
D Calling a specific station
q Program the desired code channel in advance (p. 37).
w Set the operating frequency.
•
Set the AF and squelch to the desired level as in normal opera-
tion.
e Push [A• FUNC ], then push [0• OPT ].
• Rotate [VOL] to select “dtm.PG,” if “dtm.CS” or “dtm.OF” ap-
pears.
r Select the desired transmit code channel:
➥ Push [0•
OPT ] for 1 sec. to enter the code selection con-
dition.
➥ Rotate [VOL] to select the desired code channel.
➥ Push [✱• ENT ] to return to previous condition.
• 100 MHz digit shows “P.”
t Push [PTT] to transmit the pager code.
y Wait for an answer back.
• When the transceiver receives an answer back code, the func-
tion display shows the other member’s ID or group code.
u After confirming a connection, push [A• FUNC ] and [0• OPT ]
to enter OPTION SET MODE , then rotate [VOL] to select the
code squelch operation, or repeat the previous key
operation again to select non-selective calling system.
• DO NOT push any digit keys while code channels C0 to C6 are
displayed, or code channel contents will be changed.
i Communicate with the other party as normal: push [PTT]
to transmit; release to receive.
D Waiting for a call from a specific station
q Set the operating frequency.
w Push [A•
FUNC ], then push [0• OPT ].
➥ Rotate [VOL] to select “dtm.PG,” if “dtm.CS” or
“dtm.OF” appears.
➥ Push [✱• ENT ] to return to previous condition.
• 100 MHz digit shows “P.”
e Wait for a call.
• When receiving a call, the caller’s ID or group code appears as
shown at next page.
• DO NOT push any digit keys while code channels C0 to C6 are
displayed, or code channel contents will be changed.
r Push [PTT] to send an answer back call and display the
operating frequency.
t After confirming a connection, push [A•
FUNC ] and [0• OPT ]
to enter OPTION SET MODE , then rotate [VOL] to select the
code squelch operation, or repeat the previous key
operation again to select non-selective calling system.