Instruction Manual

4
2
BASIC OPERATION
01
02
■ General description
The flow chart below shows the basic operating procedures.
You need to set the frequency, activate the frequency, and
receive or transmit.
There are two ways to set the frequency. See page 5 and 6
for details.
• Set the frequency normally • Set the frequency directly
Set the frequency normally
Set the frequency which will be used for the next operating
frequency in the standby frequency display. Then exchange
the active frequency for the standby frequency.
Set the frequency directly
You can directly enter the frequency.
Refer to ‘Directly setting the frequency.‘
TIP: For quick frequency setting, you can enter often-used
frequencies into memory channels. See “MEMORY OPER-
ATION” for details. (pp. 7–13)
When you recall a memory channel, the previous standby
frequency is erased.
Set the standby frequency.
Activate the frequency.
Enter the direct frequency
setting mode.
Set the operating frequency.
Receive/transmit