User's Manual

103
8
DV MODE OPERATION
N#ALLINGASPECIlCSTATION
This section describes how to call a specific station
using the DR mode.
When the Link repeater (R2) is set to “GW,” the des-
ignated gateway repeater is automatically set as the
Link repeater, and you can make a call to a specific
station through the internet.
q Set your own call sign.
w Hold down [DVsDR] for 1 second to select the DR
mode.
sThe last used access repeater is displayed.
- If the displayed frequency band on the SUB Band is
the same as that of the last used access repeater, se-
lecting the DR mode on the MAIN Band will automati-
cally move the frequency band on the SUB Band to
the Main Band display, and turn OFF the SUB Band
display.
e Rotate [MAIN DIAL] to select the desired access
repeater.
 s/NLYTHEREPEATERS, whose “R1USE” setting is set to
9%3OR!CCESSREPEATERSCANTARGETS are displayed.
(pp. 90, 100)
r Push [UR](F-4) to enter the UR call sign selection
mode.
t Rotate [MAIN DIAL] to select a individual station
call sign.
 s&IRST SELECTING THE station call sign memory groups
(U01–U99)BYPUSHING;43s'20=MAKESITMORECONVE-
nient.
y Hold down [UR](F-4) for 1 second to enter the Link/
Gateway repeater (R2) selection mode.
-AKINGACALLTOANINDIVIDUALSTATIONTHROUGHYOUR
LOCALAREAACCESSREPEATER,OCAL!REACALL
MY call sign：
JA3YUA
Station call sign：
JG3YMK
Repeater q ： NARA43
(JP3YHL)
q w e r
Area
Zone
u Rotate [MAIN DIAL] to select “NOT USE1.”
i Push [UR](F-4) to exit the Link repeater (R2) selec-
tion mode.
o Push [PTT] on the microphone to transmit. (or
[TRANSMIT] on the transceiver)
 s4HE-!)."AND4828INDICATORLIGHTSRED
!0 Release [PTT] to receive. (or push [TRANSMIT]
again)
s!FTERTRANSMITTINGPUSH;-7=TOENTERTHEMEMORYSE-
lect write mode. (p. 102)
[MAIN DIAL]
[D
]
NOT USE1
CS CD R>CS UR DSET
D1
R 2 :NOT US 
[TRANSMIT] [UR] [MW]
[MAIN DIAL]
MAIN Band TX/RX indicator