User's Manual

168

SET MODE

53"$!4!&UNC64. $EFAULT;'03=

Select the function of the [DATA1] jack.

s----- : The [DATA1] jack is not used.

s2449 5SEDTOSEND2449DECODEDSIGNALS

s$6DAT 5SEDFORLOWSPEEDDATAINPUTANDOUTPUT

s'03 5SEDFORTHE'03RECEIVERCONNECTIONFOR

position data input.

GPS Out 65. $EFAULT/&&

When a GPS receiver is connected to the [DATA1]

jack, the GPS position data is input through the jack.

9OUCANSELECTWHETHERORNOTTOSENDTHEDATAFROM

the COM port (“USB2”).

NOTE:9OUCANUSETHISFUNCTIONONLYWHENh-----”

or “DVdat” is selected as the “USB2/DATA1 Func”

(63) option, and “GPS” is selected as the “USB2/

DATA1 Func” (64) option.

s/&&  4URNSTHEFUNCTION/&&

s$!4! USB2 : Sends the GPS position data from

the COM port (“USB2”).

$6DAT'03/UT"AUD66. $EFAULT

Set the DV or GPS data transfer speed to 4800 or

9600 bps.

2449$ECODE"AUD67. $EFAULT

3ETTHE2449DECODEMONITORSPEEDTO

4800, 9600 or 19200 bps.

#ALIBRATION-ARKER68. $EFAULT/&&

Use as a simple frequency check of the transceiver.

See page 179 for calibration procedure.

NOTE: Turn OFF the calibration marker after check-

ing the frequency of the transceiver.

s/&&#ALIBRATIONMARKER/&&

s/. #ALIBRATIONMARKER/.

REF Adjust 69.

During frequency calibration, set the internal refer-

ENCEFREQUENCYTOBETWEENANDRANGEIN

steps.

NOTE: The default setting is different for each

transceiver.