User's Manual

QUICK REFERENCE GUIDE

N Programmed scan operation

25 pairs, 50 channels of memories are used for programmed

scan operation, that specifies a scanning ranges. The pro-

grammed scan scans between “xxA” and “xxB” (xx=00 to 24)

frequencies. Therefore, before operating the programmed

scan, different frequencies must be programmed into “A” and

“B” scan edge channels.

D Programming scan edges

A start frequency must be programmed into a “xxA,” and end

frequency must be programmed into a “xxB” memory chan-

nel.

1. Setting frequency

In the VFO mode, set a desired receive frequency selection

mode.

• When the “ ” icon is displayed, push [V/M] to select the VFO

mode.

2. Selecting a scan edge “A” channel

Hold down [S.MW](V/M)

for 1 second,

then rotate [DIAL] to

select one of the 25 scan edge “A” channels.

• The “ ” icon and scan edge channel number blink.

3. Writing a memory channel

Hold down [S.MW](V/M) for 1 second until 3 beeps sound.

• The paired scan edge “B” channel is automatically selected when

holding down [S.MW](V/M) after programming.

• When programming is completed, return to the VFO mode.

4. Selecting a scan edge “B” channel

Hold down [S.MW](V/M)

for 1 second,

then rotate [DIAL] to

select one of the 25 scan edge channel “B.”

• The “ ” icon and the scan edge channel number blink.

• When the scan edge “B” channel is already selected in step 3. (by

holding down [S.MW](V/M) after programming), skip this step.

5. Writing a memory channel

Hold down [S.MW](V/M) for 1 second until 3 beeps sound.

• The next scan edge “A” channel is automatically selected when

holding down [S.MW](V/M) after programming.

• When programming is completed, return to the VFO mode.

Quick reference guide