User's Manual

35
6
SCAN OPERATION
D Scan pause timer
The scan pauses when receiving signals according to the
scan pause time. It can be set from 2–20 seconds, or unlim-
ited.
qHold down [SET](TS) for 1 second to enter the Set mode.
wRotate [DIAL] to select the “EXPAND” item.
e While holding down [FUNC], rotate [DIAL] to turn the
Expand set mode selection ON.
rRotate [DIAL] to select the “PAUSE” item.
t While holding down [FUNC], rotate [DIAL] to set a
desired scan pausing time from 2–20 seconds (2 seconds
steps) or “HOLD.”
• “2SEC”–“20SEC”: Scan pauses 2–20 seconds while receiving
a signal.
• “HOLD” : Scan pauses on a received a signal until it
disappears.
yPush [SET](TS) to exit the Set mode.
[DIAL]
After 1 sec.
D Scan resume timer
The scan resumes after a signal disappears according to the
resume time. It can be set from 0–5 seconds, or unlimited.
qHold down [SET](TS) for 1 second to enter the Set mode.
wRotate [DIAL] to select the “EXPAND” item.
e While holding down [FUNC], rotate [DIAL] to turn the
Expand set mode selection ON.
rRotate [DIAL] to select the “RESUME” item.
t While holding down [FUNC], rotate [DIAL] to set a
desired scan pausing time from 0–5 seconds (1 second
steps) or “HOLD.”
• “0SEC” : Scan resumes immediately after the signal
disappears.
• “1SEC”–“5SEC” : Scan resumes 1–5 seconds after the signal
disappears.
• “HOLD” : Scan resumes by rotating [DIAL] only.
yPush [SET](TS) to exit the Set mode.
After 1 sec.
The scan resume timer must be set shorter than the scan
pause timer, otherwise this timer will not be activated.
N Scan resume setting
USING EXPAND SET MODE