User's Manual

37
7
PRIORITY WATCH
N Priority watch operation
D Memory channel/memory scan watch
qSelect the VFO mode; then, set an operating frequency.
wSelect the channel(s) to be watched.
For memory channel watch:
Select a desired memory channel.
For memory scan watch:
± Push [V/M] to select the memory mode.
± Hold down [SCAN](MODE) for 1 second to enter the
scan type selection mode.
± Rotate [DIAL] to select a desired scan type, then push
[SCAN](H/M/L) again to start the memory/bank scan.
eHold down [SET](TS) for 1 second to enter the Set mode.
rRotate [DIAL] to select the priority watch set item.
t While holding down [FUNC], rotate [DIAL] to select “ON.”
• Select “BELL” if the priority beep function is desired.
[DIAL]
After 1 sec.
Priority ON
yPush [TS] to exit the Set mode and start the watch.
• The “PRIO” icon appears.
• The receiver checks the memory/bank channel(s) every 5 sec-
onds.
• The watch resumes according to the selected scan resume set-
ting. (p. 31)
During priority watch
Monitors VFO frequency
for 5 seconds.
Pauses on a memory
channel when a signal is
received.
During priority watch with the priority beep
A beep tone sounds and “S” icon blinks when a signal
is received on a memory channel.
uPush [SET](TS) to cancel the watch.