User's Manual

38
7
PRIORITY WATCH
7
D VFO scan watch
qSelect the channel(s) to be watched.
For memory channel watch:
Select a desired memory channel.
For memory scan watch:
± Push [V/M] to select the memory mode.
± Hold down [SCAN](MODE) for 1 second to enter the
scan type selection mode.
± Rotate [DIAL] to select a desired scan type, then push
[SCAN](H/M/L) again to start the memory/bank scan.
wHold down [SET](TS) for 1 second to enter the Set mode.
eRotate [DIAL] to select the priority watch set item.
r While holding down [FUNC], rotate [DIAL] to select “ON.”
• Select “BELL” if the priority beep function is desired.
After 1 sec.
tPush [SET](TS) to exit the Set mode and start the watch.
• The “PRIO” icon appears.
y Hold down [SCAN](MODE) for 1 second to enter scan
type selection mode.
u Rotate [DIAL] to select a desired scan type from “ALL,”
“BAND,”
“P-LINK x (x= 0 to 9)” or “PROGxx (xx= 0–24).”
iPush [SCAN](MODE) to start the VFO scan watch.
• The receiver checks the memory channel(s) every 5 seconds.
• The watch resumes according to the selected scan resume set-
ting. (p. 31)
During VFO watch
Searches VFO frequen-
cies for 5 seconds.
Pauses on a memory
channel when a signal is
received.
During VFO scan watch with the priority beep
A beep tone sounds and “S” icon blinks when a signal
is received on a memory channel.
oPush [TS] to cancel the watch and scan.