User's Manual

68
12
MAINTENANCE
11
12
PROBLEM POSSIBLE CAUSE SOLUTION REF.
N Troubleshooting
If your receiver seems to be malfunctioning, please check
the following points before sending it to a service center.
No power comes on.
No sound comes from the
speaker.
Sensitivity is low and only
strong signals are audible.
Frequency cannot be set.
No beep sound.
Receive audio is distorted.
Desired Set mode item
cannot be selected.
Programmed scan does
not start.
Memory or bank scan
does not start.
Installed batteries cannot
be charged.
• The batteries are exhausted.
• The battery polarity is reversed.
• Volume level is too low.
• Squelch level is set too tight.
• Different tone is selected with tone squelch.
• Attenuator function is activated.
• The lock function is activated.
• Beep tones are turned OFF or the beep tone
level is too low.
• The operating mode is not selected correctly.
• “EXPAND” item is set to OFF.
• Some Set mode items can be selected in the AM
or FM broadcast band only.
• Program scan edges are not programmed.
• No or only one memory or bank channel is
programmed.
• The batteries over discharged.
• Replace the batteries or charge the batteries.
• Check the battery polarity.
• Push
[Y] to obtain a suitable level.
• While holding down [SQL], rotate [DIAL] to set the
squelch level.
• Turn the appropriate function OFF.
• While holding down [FUNC], push [SQL] to turn
the attenuator function OFF.
• While holding down [FUNC], push [
](BAND)
for 1 second to turn the function OFF.
• Turn beep tone ON or set the beep tone level to
appropriate level in the Set mode.
• Push [MODE] repeatedly to select a suitable
operating mode.
• Turn “EXPAND” item ON.
• Choose the AM or FM broadcast band.
• Program a pair of scan edge channels.
• Program at least 2 memory or bank channels
• Re-install the batteries (wait at least for 1 second),
then plug the AC adapter while holding down [FUNC].
pgs. 5, 6
p. 5
p. 11
p. 12
p. 35
p. 13
p. 10
p. 41
p. 12
p. 39
p. 7
p. 27
pgs. 16,
17
p. 6