Instruction Manual

10
3
PREPARATION
The 10 digit ATIS (Automatic Transmitter Identification Sys-
tem) code can be entered at power ON.
This initial code setting can be made only once.
After being set, it can be changed by only your dealer
or distributor. If your ATIS code has already been en-
tered, the following steps are not necessary.
q After entered the MMSI code, “Push [ENT] to Register
Your ATIS” is displayed.
w Push [ENT] to start entering the ATIS code.
• Push [CLEAR] twice to cancel the entry, and go to the normal
operating mode. In this case, the ATIS function is disabled. To
enter the ATIS code, turn OFF the power, then turn it ON again.
e Enter your ATIS code in the following manner:
• Select a desired number using Dial, or [∫]/[√]/[Ω]/[≈].
• Push [ENT] or Dial to set it.
• To move the cursor, select either arrow, “←” or “→,” then push
[ENT] or Dial.
r Repeat step e to enter all 10 digits.
t After entering the 10 digit code, “FINISH” is automatically
selected, and then push [ENT] or Dial to set it.
y The “ATIS CONFIRMATION” screen is displayed.
u Enter your ATIS code again for confirmation.
• Enter in the same manner as steps e through t.
i When your ATIS code is successfully entered, the screen
as shown below is briefly displayed.
• After that, the normal operating screen is displayed.
The entered ATIS code can be checked in the MENU screen.
(p. 74)
 Entering the ATIS code (For Dutch and German version transceivers)