User's Manual

New2001
35
New2001
TROUBLESHOOTING
8
To communicate through the repeater, your signal must access to the repeater. When your signal accesses your local repeater,
but it is not sent to the destination repeater, the repeater replies with an status message.
PROBLEM POSSIBLE CAUSE SOLUTION REF.
After your call, the repeater does
not return a status reply.
•Therepeatersettingiswrong.
•Yourtransmissiondidnotreachtherepeat-
er.
•Selectthecorrectrepeater.
•Correct the repeater frequency, frequency
offset, or duplex setting.
•Waituntilyouareclosertotherepeaterand
try again.
•Tr ytoaccessanotherrepeater.
p. 17
—
—
After your call, the repeater re-
plies ‘UR?’ and its call sign.
•Thecallwassuccessfullysent,butnostation
immediately replied.
•Waitforawhile,andtryagain. —
After your call, the repeater re-
plies ‘RX’ or ‘RPT?’ and the ac-
cess repeater’s call sign.
•Yourowncallsign(MY)hasnotbeenset.
•Your own call sign (MY) has not been reg-
istered on a gateway repeater, or the regis-
tered contents do not match your transceiv-
er’s setting.
•Setyourowncallsign(MY).
•Registeryourowncallsign(MY)onagate-
way repeater, or confirm the registration of
the call sign.
p. 2
p. 4
After your call, the repeater re-
plies ‘RPT?’ and call sign of the
destination repeater.
•Therepeatercannotconnecttothedestina-
tion repeater.
•Therepeateris busy.
• Checktherepeatersetting.
• Wait for a while, and try it again.
p. 17
—
After your call, the access repeat-
er replies ‘RPT?’ and its call sign.
•The call sign of the destination repeater is
wrong.
•Correctly set the destination repeater call
sign.
—